How to change classical guitar strings
Chains have become discolored or brown? Classical guitar tones is affected somewhat by the quality of the strings. Time to change the strings! The process of replacing strings on a classical guitar is slightly different acoustic or electric guitar.
To begin with, classical strings are made of nylon. The lowest of three strings, E, A and D are wound with nickel. When the choice of strings for classical guitar, paying special attention you do not choose acoustic (steel) strings. The tension of these strings are adjusted or crack the neck of the guitar. Some manufacturers of the quality of classical strings include Augustine, Eagle, and D’Addario. Some brands like Augustine come in different strains that can be chosen depending on what tone you desire. Chains usually run about $ 5.00-10.00 a set.
Once you have selected your channels is time to start the process by removing the old strings. In turn the ears of the people of the guitar until it no longer wraps around the pin and out the hole in the plug. Then remove the chains of the bridge. You can make this easier to push down on the line to release the whole bridge.
Once the chains are removed, this is a good time to clean your guitar. Use a soft cloth to remove dust from the population, neck and body around the hole of sound.
When ready to put the new strings, has the largest chain of metal out from the pack and rest him. Take one end and insert it into the small hole in the bridge position closest to you, where the low E string belongs. Insert it into the whole sound to the grand final of the body. Now pull about 4-5 cm through the hole. Take the short end of the rope and put it on the bridge. Pass under the other end of the chain. Now take the string wraps around and around the chain at the top of the bridge several times. Generally, you can wrap around 2-3 times. Once you’ve wrapped several times to pull each end of the rope to tighten the bridge.
Now go to the first adjustment pin on the population (the one closest to you.). turn, so that the hole is aligned with the neck of the body. Take the chain to the population. Make sure the chain passes through its corresponding slot in the nut. Now take the long end of the string and put it through the hole of the plug. Tighten the string and take the string around the peg and to bind itself to parity. Holding the loose end of the chain of teaching with one hand, are turning the peg slowly in a counter clockwise to the other hand. You can use a tuner for the chain to E. low about not worrying about the exact, can be adjusted later. In fact, the melody a few steps above what it should be. The string will be very elastic for a couple of days and then reduced with a tone rather quickly.
Now make sure both ends of the string look strong and that the ends do not slip. Now repeat the process with the rest of the strings, down the guitar. The order of the strings next five years is: A, D, G, B, E.
Once you have set all the strings, tune the guitar and play a bit to make sure everything feels good. For a couple of days you should tune the guitar a little too high before storage between use.
A good way to extend the life of your strings is to wash your hands before touching the guitar. Keeping it in his case between the use of protected from dust and dirt in the air.
Related posts: